Shake well before use.

Get ready with 2 pieces of a brand new, lint-free microfiber towel. (It is recommended that new towels to be rinsed or washed with water prior to use to reduce the loosing lint)

It is recommended to do a 2 ft. x 4 ft. area or 4 ft. x 4 ft. at a time.

Spray on AUTOTRIZ 3D Matrix Booster on the surface.

Wait for 30 seconds (time is vary from different countries and different seasons depending on temperature or humidity, ask distributors for recommendations), and use the first towel to remove the product.

Go immediately over with a second microfiber towel with a polishing motion until the surface is free from residue.

When the whole car is applied, allow curing of 1-2 hours.

INSPECTION LIGHTING SYSTEM

Lighting is of utmost importance during the application of a coating to paint. Spot Light like Scangrip is a good lighting system to inspect paint defects during polishing but in fact, it is NOT RECOMMENDED to use to check the residue of coating left on the paint. The suitable lighting system is Diffused Light.

**NOTE
The product is supplied with a cap and trigger sprayer nozzle separately. Always tighten the bottle with a cap after every use. The trigger sprayer nozzle should be emptied and air-dried for the next use to avoid blockage.