SEJA UM DISTRIBUIDOR
TORNE-SE UM APLICADOR
MARCA PRIVADA
A morale booster of an extraordinary experience for an improved maintenance
BOOST UP.
HYDROPHOBICITY.
THE REAL ENHANCEMENT SOLUTION
Next-level maintenance solution that has an impressive result in making maintenance better, faster, and easier.
COMMON PROBLEMS ON COATING
Lose Hydrophobicity
Deterioration of hydrophobic effect over time
Stain
Dirt and dust build up on paint
Smoothness
Reduce of smoothness to touch
BENEFÍCIOS
Hyper Smooth Effect
Advanced Polysilazane technology that offer a hyper-smooth and slick effect after maintenance.
Boost Performance
Boosts coating performance and durability such as hydrophobicity, smoothness, and resistance.
Ultimate Coating Maintenance
Contains a micro-thin layer of Polysilazane protection that enriches smoothness and protection eliminating surface contamination, and water spotting.
Easy Application
Just spray on and wipe off with a microfiber to obtain the satisfying result.
CARACTERÍSTICAS PRINCIPAIS
Hyper Smooth
Ensures a super slick and hyper-smooth surface that repels dirt.
Cure Fast
Fast application. Achieve maximum result in just a single day
Super Hydrophobic
Protects the surface with a long-lasting super hydrophobic layer.
UV protection
Preserves valuable surfaces against fading caused by UV rays.
Easy-to-Clean
Spills and dirt can be cleaned up easily without leaving any stains.
Anti-static
Reduce surface friction and prevent the build-up of dust/dirt.
Instruções de uso
Shake well before use.
Get ready with 2 pieces of a brand new, lint-free microfiber towel. (It is recommended that new towels to be rinsed or washed with water prior to use to reduce the loosing lint)
It is recommended to do a 2 ft. x 4 ft. area or 4 ft. x 4 ft. at a time.
Spray on AUTOTRIZ 3D Matrix Booster on the surface.
Wait for 30 seconds (time is vary from different countries and different seasons depending on temperature or humidity, ask distributors for recommendations), and use the first towel to remove the product.
Go immediately over with a second microfiber towel with a polishing motion until the surface is free from residue.
When the whole car is applied, allow curing of 1-2 hours.
INSPECTION LIGHTING SYSTEM
Lighting is of utmost importance during the application of a coating to paint. Spot Light like Scangrip is a good lighting system to inspect paint defects during polishing but in fact, it is NOT RECOMMENDED to use to check the residue of coating left on the paint. The suitable lighting system is Diffused Light.
**NOTE
The product is supplied with a cap and trigger sprayer nozzle separately. Always tighten the bottle with a cap after every use. The trigger sprayer nozzle should be emptied and air-dried for the next use to avoid blockage.