Buff the glass surfaces thoroughly with Glass Compound (Cerium Oxide based) to remove any contaminants or water spots. Make sure the surface becomes hydrophilic.

Prep with n-butyl acetate or Isopropyl alcohol (IPA) to make sure the surface is completely dry and free of oils.

Mix the AUTOTRIZ Glass Pro Coating (Base) and Glass Pro Coating (Reactor) with a 1:1 ratio in a volume cup

Use 5ml+5ml for a windscreen; 15ml+15ml for a whole car.

Wrap the applicator sponge with the white microfiber suede cloth that comes with the box or use the applicator of your preference.

Use a syringe to pump in and out of the product mixture on the applicator.

Wipe on the entire windshield beginning on the driver’s side and then passenger side. Apply one layer of the product by working in horizontal movement only (front and rear windscreen) using medium pressure to ensure that product is carried through evenly in a thin layer.

Apply a second layer following to ensure complete coverage.

A mixture of AUTOTRIZ Glass Pro Coating is absorbed into the microscopic pores of glass instantly, instead of forming a layer on top of the glass surface.

Wait at least 30 minutes; the coating film can stay on the glass as long as it can.

Wipe off completely using clean microfiber towels until all residue is removed. If you feel hard to buff off the residue, it means that you applied the product too thick. It should be spread as thin as possible.

**NOTE
AUTOTRIZ Glass Pro Coating must be used within 30 minutes after mixing as it will lose its functionality after the chemical reaction periods. Finish all the mixture and do not re-use for the next application. Do not expose to water within 4 hours. Do not turn on wipers for 24 hours for maximum durability.