Shake well before use.

Get ready with 3 pieces of a brand new, lint-free microfiber towel. (It is recommended that new towels to be rinsed or washed with water prior to use to reduce the loosing lint)

When first applying AUTOTRIZ PPF & Vinyl Wrap Coating on the substrate, it is recommended to condition the surface of the puff applicator with 7-8 drops to prevent skipping or dry spots.

Do not work on a large area at a time. It is recommended to do a 2 ft. x 2 ft. area at a time.

Apply AUTOTRIZ PPF & Vinyl Wrap Coating using normal pressure on the applicator. Make sure the area is well covered. Always start from an edge to avoid excess on other panels. Work in controlled areas to remember where you previously applied. Work in horizontal or vertical movements to ensure that product is carried through consistently.

AUTOTRIZ PPF & Vinyl Wrap Coating is tacky and feels sticky like glue to remove. Wait for 5-10 seconds only. Use the first towel to buff off the product using harder pressure.

Go immediately over with a second microfiber towel with polishing motion until the film is completely free from residue.

Follow by the third towel (this is called the “insurance towel”) and go over the surface one extra time just to make sure you haven’t missed any streaks or excess residue just to make sure you haven’t missed any streaks or excess residue.

When the whole car is applied, allow the curing of the coating to begin.

If a white haze appears, it is normal. They will disappear after to coating is cured.

Wait approximately 30-60 minutes before applying a second layer.

Curing times depend on temperature and humidity. Curing can be accelerated using IR Lamps. Follow the lamp manufacturer's recommended settings.