The world's most durable coating for windscreen. No one can ever compete!
YOUR WINDSCREEN.
CLEARER. SAFER.
THE MOST DURABLE WINDSCREEN PROTECTION
Unlike regular rain repellent products that adhere to the surface of glass using relatively weak physical bonds, Autotriz Glass Pro fluorine technology gives your vehicle windscreen extreme durability against abrasion of wiper blades. Its super hydrophobic properties allow rain flowing off glass surface at low driving speed. Autotriz Glass Pro unique formula provides exceptional optical clarity by cutting glares at night.
THE UNDENIABLE PROTECTION
World’s strongest fluorine based windshield protection that provides the highest performance for a safer drive.
COMMON PROBLEMS ON WINDSCREEN
Rain
Driving in rain under poor visibility is a major cause of accidents
Glares
Glare and blur vision during the night due to formation of oil film
Bugs & Insects
Stubborn stains affecting driver's visibility and safety
혜택
Outstanding Abrasion Resistance against Wiper
Passed 600,000 times TABER Abrasion Test according to ISO 4649 / DIN 53516
Water Repellent Effect Lasts Up to 12 Months
High durability with long-lasting performances with single application
Fluorine-Based Formula
An unique two-component fluorine based coating to ensure durability in the long run.
Wiper-less Speed At Approx. 80km/h
Wipers are no longer needed while driving at higher speed
주요 특징들
Anti-Skid Technology
Friendly to wiper blades and does not result in squeaking noise.
Easy-to-Clean Surface
The windscreen can be cleaned off with normal wiper cleaning.
Improves Visibility
Provides a crystal-clear vision while driving in rain.
Chemical Resistant
Protect against strong cleaning chemicals and washer fluid
Eliminate Water Mark
Highly resistant to water marks
Super Slick Surface
Reduce friction between wiper blades and windshield.
사용 지침
Buff the glass surfaces thoroughly with Glass Compound (Cerium Oxide based) to remove any contaminants or water spots. Make sure the surface becomes hydrophilic.
Prep with n-butyl acetate or Isopropyl alcohol (IPA) to make sure the surface is completely dry and free of oils.
Mix the AUTOTRIZ Glass Pro Coating (Base) and Glass Pro Coating (Reactor) with a 1:1 ratio in a volume cup
Use 5ml+5ml for a windscreen; 15ml+15ml for a whole car.
Wrap the applicator sponge with the white microfiber suede cloth that comes with the box or use the applicator of your preference.
Use a syringe to pump in and out of the product mixture on the applicator.
Wipe on the entire windshield beginning on the driver’s side and then passenger side. Apply one layer of the product by working in horizontal movement only (front and rear windscreen) using medium pressure to ensure that product is carried through evenly in a thin layer.
Apply a second layer following to ensure complete coverage.
A mixture of AUTOTRIZ Glass Pro Coating is absorbed into the microscopic pores of glass instantly, instead of forming a layer on top of the glass surface.
Wait at least 30 minutes; the coating film can stay on the glass as long as it can.
Wipe off completely using clean microfiber towels until all residue is removed. If you feel hard to buff off the residue, it means that you applied the product too thick. It should be spread as thin as possible.
**NOTE
AUTOTRIZ Glass Pro Coating must be used within 30 minutes after mixing as it will lose its functionality after the chemical reaction periods. Finish all the mixture and do not re-use for the next application. Do not expose to water within 4 hours. Do not turn on wipers for 24 hours for maximum durability.